Ridetech Front 2 Inch Drop Spindles for 1978-1988 GM G-Body
The Ridetech Front 2 Inch Drop Spindles, MPN 11329300, are a front spindle pair for a 1978-1988 GM G-body, including the Cutlass, Cutlass Supreme, El Camino, Grand National, Grand Prix, LeMans, Malibu, Monte Carlo, and Skylark. The spindles provide a 2 inch front drop and are sold in pairs. These spindles are not compatible with Ridetech coil-over and air suspension systems.
Key Features
- Front 2 inch drop spindles, sold in pairs
- Bolts to the factory upper and lower ball joints
- Not compatible with Ridetech coil-over and air suspension systems
- Part number 11329300
- Ships as spindle pair 11329300, sold as a set of 2
Fitment
| Vehicle Application | Position |
|---|---|
| 1978-1988 GM G-body (Cutlass, Cutlass Supreme, El Camino, Grand National, Grand Prix, LeMans, Malibu, Monte Carlo, Skylark) | Front |
Specifications
| Detail | Value |
|---|---|
| MPN | 11329300 |
| Retailer SKU | RID11329300 |
| Drop | 2 in |
| Quantity | Sold in pairs |
What’s Included
- 2 front drop spindles
About Ridetech
Ridetech engineers air suspension, coilovers, and chassis components in the USA and tests every system on real vehicles. Spindle pair 11329300 is part of Ridetech’s GM G-body suspension lineup.
Related Parts
- Ridetech Outer Tie Rod End for 1978-1987 G-Body
- Ridetech Steering Linkage Kit for 1978-1988 G-Body
FAQ
Can I use these spindles with a Ridetech coil-over kit?
No. These drop spindles are not compatible with Ridetech coil-over and air suspension systems.
How much do these spindles lower the front?
These spindles provide a 2 inch front drop.
How many spindles come in this kit?
The spindles are sold in pairs, one for each side.
Does this fit a Grand National?
Yes. These spindles fit all 1978-1988 GM G-body models, including the Buick Grand National.
Do these spindles work with the factory ball joints?
Yes. The spindles bolt to the factory upper and lower ball joints.
Does this fit a Skylark?
Yes. The 1978-1988 Buick Skylark shares the GM G-body platform covered by these spindles.
Will I need an alignment after installing these spindles?
Yes. A front-end alignment is required after replacing spindles.
Do these spindles change the steering geometry?
Dropping the spindle changes ride height and can affect bumpsteer, so verify tie rod geometry after installation.
Installation Instructions
- Raise the front of the vehicle and support it on jack stands
- Remove the front wheels
- Disconnect the brake caliper, tie rod end, and ball joints from the factory spindle
- Remove the factory spindle
- Install the new drop spindle to the upper and lower ball joints
- Reconnect the brake caliper and tie rod end, then torque all fasteners to the manufacturer’s specification
- Lower the vehicle and have the front end aligned before driving
California Proposition 65 Warning
WARNING: This product can expose you to chemicals including those known to the State of California to cause cancer and reproductive harm. For more information, visit www.P65Warnings.ca.gov.
