Front HQ ShockWaves for a Controlled, Confirmed Fit
The Ridetech 11312401 is a front hq shockwaves for the vehicle applications listed below. HQ Series single-adjustable, 26 rebound clicks cited on page. For stock control arms.
Key Features
- Ridetech part number 11312401
- Front air suspension ShockWave pair (HQ Series)
- For stock control arms
- Requires air compressor and control system
Fitment
| Vehicle Application | Position |
|---|---|
| 1991-1996 GM B-body: Chevrolet Impala/Caprice, Buick Roadmaster, Cadillac Fleetwood, Oldsmobile (B-body) | Front |
Specifications
| Detail | Value |
|---|---|
| Manufacturer Part Number | 11312401 |
| Brand | Ridetech |
| Condition | New |
| Shipping Weight | 18 lbs |
| Specification | HQ Series single-adjustable, 26 rebound clicks cited on page |
| Specification | Impact-forged monotube aluminum body |
What’s Included
- 2 HQ Series ShockWave air spring and shock units
Related Parts
- 58-64 Impala Front CoolRide Kit (For use with StrongArms)
- 58-64 Chevy Impala MuscleBar Sway Bar Rear
- 59-64 Chevy Impala StrongArms Rear Upper
- 59-64 Chevy Impala Panhard Bar
About Ridetech
Ridetech 11312401 is manufactured in the USA. Specifications and fitment above apply to Ridetech 11312401. Sold under Ridetech part number 11312401. Ridetech engineers air suspension, coilovers, and chassis components in the USA and tests every system on real vehicles before it ships. The lineup covers bolt-on street and pro-touring suspension for classic muscle cars, trucks, and modern performance vehicles.
FAQ
Will this fit my vehicle exactly as listed
Check the fitment table above for the exact years, make, and model this part covers. Some model years use different rotor or trim configurations, so confirm your specific submodel before ordering if one is noted.
What is included in the box
This listing includes the component itself. Mounting hardware is included only when stated in the specifications table above.
Do I need any special tools to install this
Basic hand tools are typically sufficient for installation. A torque wrench is recommended to bring fasteners to the manufacturer’s specified torque.
Is this a direct replacement for the factory part
Yes, this part is designed as a direct fit replacement for the listed applications using the factory mounting points, so no vehicle modification is required.
What is the expected break-in or service period
Standard break-in and service intervals apply. Follow the installation instructions below for the recommended break-in procedure to reach full performance.
Can I install this myself or do I need a professional
Many owners install this part themselves with common tools and a lift or jack stands. If you are not comfortable with brake or suspension work, a certified technician is recommended.
Does this come with a warranty
This part is covered by the manufacturer’s standard warranty against defects in materials and workmanship. Retain your receipt as proof of purchase.
Will this work with my aftermarket wheels
Most stock-diameter aftermarket wheels clear this part without issue. If you run very low-offset or small-diameter wheels, verify clearance before ordering.
Installation Instructions
- Raise the vehicle and support the chassis on jack stands
- Remove the wheel to access the factory shock or spring
- Support the control arm or axle before disconnecting the factory component
- Remove the factory shock, spring, or strut assembly
- Install the new Ridetech unit using the factory or included mounting hardware
- Torque all fasteners to the manufacturer’s specification
- Connect the air line or electrical harness if equipped, following the included instructions
- Repeat on the opposite side, then cycle the suspension and check for clearance before driving
